industrias deu s.a. maquinaria de inyeccion de plasticos
alta a la newsrecomienda a un amigo

News Octubre 08  
download PDF PDF  

 

 

 

ISO 9001


EXPERT - MOLDING INJECTION MACHINES


Expert Series: Clamping force of 8.500 kN. - 26.000 kN. (Access the injector models on the menu to the left)

EQUIPMENT COMMON TO ALL SERIES.

Descarga PDF

SAFETY AND CONTROL SYSTEM
maquinariaDeInyecciónTermoplásticos-- Unviolable twin circuit course stops.

-- Safety circuit pursuant to CE standards based on a twin signal with an independent emergency circuit.

-- Electronic control of modular plates.

-- Automation and control panel with industrial PC architecture.

-- Color screen for supervising the process with clamping, injection and temperature data as well as for pressure speed and time.

-- Screen with injection parameters with 6 filling stages controlled by position, pressure and speed. Pressure maintenance with 4 stages controlled by pressure, speed and time.

-- Screen with graph of the profile of real injection and maintenance pressures.

-- Semiautomatic and automatic expulsion model, control of number of strikes (up to 99) or vibration with different regulation for the first and following expulsions.

-- New attempt at expulsion if piece is not detected by photocells (optional) or if it is trapped upon closing (mold safety).

-- Core controllable by time, end of courses or number of turns in the case of screwdrivers.

-- Screen for monitoring and storing the production cycle's main values.

-- Memory for storing 200 molds.


HYDRAULIC SYSTEM

-- Intelligent hydraulic circuit with major energy savings.

-- Additional circuit for the mold's safety.

-- Automatic regulation of oil temperature.

-- Sensor that detects minimum oil level

-- External and continuous oil filter via bypass.

-- Valves, cartridge blocks and tubes that are completely accessible at the rear part of the machine.

-- Valves, pumps, connections, etc approved according to European standards.

-- Oil preheating system

CLAMPING UNIT

-- Twin kneepads with five support points.

-- Well ribbed, robust and extra large plate.

-- Well ribbed moveable plate with reinforcement bridge in expulsion zone, robust and extra large with bronze/graphite bearings on the columns.

-- Two Roll support system for moveable plate on bedplate.

-- Mold automatic adjustment via photoelectric sensor.

-- Two precision linear transducers to control the moveable plate's opening position and expulsion.

-- Hydraulic ejector regulated by pressure, speed and position.

-- Moveable plate with four scales for regulating pressure and speed in terms of position.

-- 1 or 2 hydraulic cores according to machine model.

-- 1 air valve.

INJECTION UNIT

-- Modular anchoring system for installing the model immediately above the injection unit.

-- Rotating of the injection gear to facilitate changing the chamber and/or spindle.

-- High par hydraulic motor directly coupled to spindle without any intermediate elements.

-- Load back pressure commanded by the C6000 control.

-- A precision linear transducer to control the injection and loading position.

-- A linear transducer for bringing the injection car near.

-- Sensor to control injection pressure.

-- Injection via two pistons balanced on either side of the injection spindle.

-- Two hydraulic cylinders in a position symmetric to the spindle for injection group movements.




print friendly >>
minimodularmedium consultasexpert